The new Edelux II "raises the bar" for dynamo headlights. The beam is wider, more even, and no longer is there a dark near field area (directly in front of the bike).
The beam is asymmetric (like an automotive low beam) and concentrates the light on the road where it is needed most. Glare for oncoming riders and drivers is reduced. For added safety, a stand light glows for several minutes when the rider stops.
The Edelux II has a three position switch (on/senso/off). In senso mode it will automatically come on in low light (like a tunnel or deep shadows) for safety. The glass lens has a non-glare coating for maximum efficiency and durability. The housing is completely sealed against moisture.
We stock it with a 140 cm wire and bare wire ends. We include loose 4.8mm spade connectors (for Schmidt hubs) at no charge or install them at a specified length for $12 (make a note in the comment field at checkout for this service).
140cm wire with loose spade connectors included. We can cut cable to length and install connectors for a $12 additional charge if you prefer (see note above). Make note that this may delay shipment by 24hrs, but generally will not.
90 lux output - SUPER BRIGHT!
On/Off and Senso mode (3 position switch)
Can be used with, or without, a tail light.
Aluminium casing and copper heat sink for efficient dissipation of heat from the LED.
Available in black anodized, silver anodized, polished aluminium, or red anodized.